Toyota Camry (XV70): Inspection
INSPECTION
PROCEDURE
1. INSPECT MAGNET CLUTCH ASSEMBLY
|
*a | Component without harness connected (Magnet Clutch Assembly) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|---|---|---|
|
1 (SSR+) - 2 (SSR-) | 20°C (68°F) |
160 to 320 ? |
2. INSPECT COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID)
|
*a | Component without harness connected (Cooler Compressor Assembly (Compressor Solenoid)) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|---|---|---|
|
1 (SOL-) - 2 (SOL+) | 25°C (77°F) |
10.1 to 11.1 ? |
3. INSPECT MAGNET CLUTCH ASSEMBLY
|
*a | Component without harness connected (Magnetic Clutch Assembly) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|---|---|---|
|
3 (MG+) - Cooler compressor assembly body |
20°C (68°F) | 3.8 to 4.2 ? |
(b) Connect a positive (+) lead from the battery to connector terminal 3 (MG+) and a negative (-) lead to the cooler compressor assembly and check that magnetic clutch assembly operates.
Standard:
|
Tester Connection | Specified Condition |
|---|---|
|
Battery positive (+) > 3 (MG+) Battery negative (-) > Cooler compressor assembly body |
Operating sound is heard and magnetic clutch hub and rotor lock |
READ NEXT:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL MAGNET CLUTCH ASSEMBLY
(a) Secure the cooler compressor assembly in a vise between aluminum plates.
(b) Install the magnet clutch stator with the parts aligned as
Installation
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL
(a) When replacing the compressor assembly with magnetic clutch with a new one:
(1) Remove the drain bolt (seal washer) from a new compressor asse
SEE MORE:
Transmitter ID 1 not Received (Main) (C2121-C2125,C2181-C2185)
DESCRIPTION The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressure of each wheel. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measured tir
Cruise Control Input Processor (P160700)
DESCRIPTION When the ECM detects that it is not functioning normally, DTC P160700 is stored.
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL DTC Output from
P160700 Cruise Control Input Processor
When the ignition switch is ON and control of vehi
