Toyota Camry (XV70): All Doors LOCK/UNLOCK Functions do not Operate Via Master Switch
DESCRIPTION
The main body ECU (multiplex network body ECU) receives switch signals from the multiplex network master switch assembly and driver door key cylinder lock or unlock switch signals from the front door lock with motor assembly LH. The main body ECU (multiplex network body ECU) activates the door lock motor on each door according to these signals.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
- The power door lock control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power door lock control system after confirming that the communication systems are functioning properly.
Click here
.gif)
- Before replacing the main body ECU (multiplex network body ECU), refer to Registration.*
Click here
*: w/ Smart Key System
PROCEDURE
|
1. | CHECK FOR DTC (LIN COMMUNICATION SYSTEM) |
(a) Clear the DTCs.
Body Electrical > Main Body > Clear DTCs(b) Recheck for DTCs.
Body Electrical > Main Body > Trouble CodesOK:
DTC B1206 is not output.
| NG | .gif) | GO TO LIN COMMUNICATION SYSTEM (DTC B1206) |
|
.gif)
| 2. |
REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY |
(a) Replace the multiplex network master switch assembly.
Click here
|
| 3. |
CHECK DOOR LOCK OPERATION |
(a) Check that all doors can be locked and unlocked by the multiplex network master switch assembly.
Click here
OK:
All doors can be locked and unlocked by the multiplex network master switch assembly.
| OK | | END (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WAS DEFECTIVE) |
| NG | | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
|
READ NEXT:
All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch
DESCRIPTION The main body ECU (multiplex network body ECU) receives switch signals from the door control switch assembly and activates the door lock motor on each door according to these signals. WIRI
Improper Operation
DESCRIPTION In cases where the doors locked or unlocked by themselves even though a door lock or unlock operation was not performed, a vehicle malfunction, accidental operation by the customer or a pa
SEE MORE:
Components
COMPONENTS ILLUSTRATION
*1 VVT SENSOR (for Intake Side of Bank 1)
*2 VVT SENSOR (for Exhaust Side of Bank 1)
*3 VVT SENSOR (for Intake Side of Bank 2)
*4 VVT SENSOR (for Exhaust Side of Bank 2)
N*m (kgf*cm, ft.*lbf): Specified torque
High Beam Headlight Circuit
DESCRIPTION The main body ECU (multiplex network body ECU) controls the high beam headlights. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
Check the operation of the low beam headli
