Toyota Camry owners & service manuals

Toyota Camry (XV70): Dtc Check / Clear

Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Window / Glass / Power Window Control System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

Body Electrical > Master Switch > Trouble Codes Body Electrical > D-Door Motor > Trouble Codes Body Electrical > P-Door Motor > Trouble Codes Body Electrical > RL-Door Motor > Trouble Codes Body Electrical > RR-Door Motor > Trouble Codes

(e) Check the details of the DTCs.

Click here

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / Clear DTCs.

Body Electrical > Master Switch > Clear DTCs Body Electrical > D-Door Motor > Clear DTCs Body Electrical > P-Door Motor > Clear DTCs Body Electrical > RL-Door Motor > Clear DTCs Body Electrical > RR-Door Motor > Clear DTCs

(e) Clear the DTCs.

    READ NEXT:

     Fail-safe Chart

    FAIL-SAFE CHART PULSE FAILURE (a) If a pulse sensor built into the power window regulator motor assembly malfunctions, the following power window operations will be prohibited. Multiplex Network Maste

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts.

     Diagnostic Trouble Code Chart

    DIAGNOSTIC TROUBLE CODE CHART Power Window Control System DTC No. Detection Item Link B2311 Power Window Motor Malfunction B2311 Power Window Motor Malfu

    SEE MORE:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL FUEL LID OPENER SWITCH (a) Engage the 2 claws to install the fuel lid opener switch as shown in the illustration. Install in this Direction 2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY Click here 3. CONNECT HOOD LOCK CONTROL

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced starter assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Rep

    © 2023-2026 Copyright www.tocamry.com