Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | TRANSMISSION VALVE BODY ASSEMBLY |
*2 | TRANSAXLE CASE GASKET |
|
*3 | NO. 1 FRONT OIL PUMP COVER GASKET |
*4 | NO. 2 FRONT OIL PUMP COVER GASKET |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
● | Non-reusable part |
.png) |
Toyota Genuine ATF WS |
- | - |
ILLUSTRATION
|
*1 | MANUAL VALVE |
*2 | SOLENOID (SL) VALVE |
|
*3 | SOLENOID (SL1) VALVE |
*4 | SOLENOID (SL2) VALVE |
|
*5 | SOLENOID (SL3) VALVE |
*6 | SOLENOID (SL4) VALVE |
|
*7 | SOLENOID (SL5) VALVE |
*8 | SOLENOID (SL6) VALVE |
|
*9 | SOLENOID (SLU) VALVE |
*10 | SOLENOID (SLT) VALVE |
|
*11 | SOLENOID LOCK PLATE |
- | - |
|
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
Toyota Genuine ATF WS |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tr
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MANUAL VALVE
(a) Remove the manual valve from the transmission valve body assembly.
2. REMOVE SOLENOID LOCK PLATE
(a) Remove the 3 bolt
Inspection
INSPECTION PROCEDURE 1. INSPECT SOLENOID (SL) VALVE
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
S
SEE MORE:
Torque Converter Clutch Actuator Stuck On (P07407E)
DESCRIPTION The ECM uses signals from the throttle position sensor, mass air flow meter, transmission revolution sensor (NT), transmission revolution sensor (NC) and crankshaft position sensor to help determine the engagement timing of the lock-up clutch. The ECM monitors the engagement of the clutc
Torque Sensor Zero Point Adjustment Undone (C1515)
DESCRIPTION This DTC does not indicate a malfunction. The power steering ECU (rack and pinion power steering gear assembly) stores this DTC when it determines that torque sensor zero point calibration has not been performed.
When the IG terminal voltage is below 8 V, torque sensor zero point cali
© 2023-2026 Copyright www.tocamry.com
