Toyota Camry (XV70): Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE LUGGAGE COMPARTMENT DOOR OPENER SYSTEM
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
HINT:
The following items can be customized.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Door Lock.
(5) Select the setting by referring to the table below.
Door Lock|
Tester Display | Description |
Default | Setting |
ECU |
|---|---|---|---|---|
| Trunk Link with Door Lock |
Function that opens the luggage compartment door when the luggage electrical key switch is pressed and all doors are unlocked using the entry door lock function, wireless door lock function, mechanical key or door control switch.* |
ON | 0:OFF,1:ON |
Main body ECU (Multiplex network body ECU) |
- *: w/ Smart Key System
(6) Enter the following menus: Customize Setting / Others.
(7) Select the setting by referring to the table below.
Others|
Tester Display | Description |
Default | Setting |
ECU |
|---|---|---|---|---|
| Trunk / Fuel Opener SW Operation Setting |
Function that sets the luggage compartment door opening switch assembly operation. Short: Luggage compartment door open request sent when luggage compartment door opening switch assembly pushed. Long: Luggage compartment door open request sent when luggage compartment door opening switch assembly pushed for 0.8 seconds. |
Long | 0:Short,1:Long |
Main body ECU (Multiplex network body ECU) |
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in or
Terminals Of Ecu
TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
(a) Remove the main body ECU (multiplex network body ECU) from the instrument panel j
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL TIMING CHAIN COVER ASSEMBLY
(a) Clean the contact surfaces of the engine assembly, and confirm that no oil, moisture, or other foreign matter is on the surfaces.
*a Engine Assembly Side
*b Timing Chain Cover Assembly Side
Clean
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT
HINT: Perform the removal and installation of the front disc brake piston, cylinder boot and piston seal one side at a time. PROCEDURE
1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG (a) Temporarily install the front disc brake bleeder plug to the front di
