Toyota Camry (XV70): DCM System Internal Failure (B15A804)
Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Cellular Communication / Safety Connect System / DCM System Internal Failure (B15A804)
DESCRIPTION
This DTC is stored when an internal circuit malfunction is detected by the DCM (telematics transceiver) self check.
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
B15A804 | DCM System Internal Failure |
DCM (telematics transceiver) internal malfunction |
DCM (telematics transceiver) |
CAUTION / NOTICE / HINT
NOTICE:
- Regardless of whether DTC B15A804 has been output as a present or history DTC, the DCM (telematics transceiver) should be replaced.
- Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.
Click here
.gif)
PROCEDURE
|
1. | REPLACE DCM (TELEMATICS TRANSCEIVER) |
(a) Replace the DCM (telematics transceiver) with a new one.
Click here
NOTICE:
- The engine switch must be off.
- Do not exchange the DCM (telematics transceiver) with one from another vehicle.
| NEXT | .gif) | PERFORM DCM ACTIVATION |
READ NEXT:
GNSS Antenna Circuit Short to Ground (B15C111,B15C113)
DESCRIPTION These DTCs are stored when a malfunction occurs in the telephone and GPS antenna (for Roof Side) circuit.
DTC No. Detection Item
DTC Detection Condition Trouble Area
Airbag Signal Signal Plausibility Failure (B15C464)
DESCRIPTION If the DCM (telematics transceiver) detects an error in communication between the DCM (telematics transceiver) and the airbag sensor assembly as a result of the DCM (telematics transceiver
Emergency Call Switch Circuit Short to Ground (B15C511,B15C513)
DESCRIPTION If the DCM (telematics transceiver) detects an error in the communication between the DCM (telematics transceiver) and the roof console box sub-assembly (manual (SOS) switch) as a result o
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below. Necessary Procedures After Parts
Key Reminder Buzzer does not Sound
DESCRIPTION The key reminder warning buzzer sounds when the driver door is opened while the ignition switch is off or ACC. The key reminder warning buzzer is activated when the main body ECU (multiplex network body ECU) sends an unlock warning switch signal and driver door courtesy light switch sign
© 2023-2026 Copyright www.tocamry.com
