Toyota Camry (XV70): Electronic Circuit Inspection Procedure
ELECTRONIC CIRCUIT INSPECTION PROCEDURE
BASIC INSPECTION
(a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS
(1) Unless otherwise stated, all resistance measurements are standard values measured at an ambient temperature of 20
READ NEXT:
HOW TO PROCEED WITH TROUBLESHOOTING OPERATION FLOW
HINT: Perform troubleshooting in accordance with the procedure below. The following is an outline of basic troubleshooting procedure. Confirm the t
GENERAL INFORMATION GENERAL DESCRIPTION (a) This manual is written in accordance with SAE J2008.
(b) Repair operations can be separated mainly into the following 3 processes:
(1) Diagnosis (2) Rem
SEE MORE:
INSTALLATION PROCEDURE 1. INSTALL STUD BOLT
HINT: If a stud bolt is deformed or the threads are damaged, replace it.
(a) Using an E6 "TORX" socket wrench, install the 2 stud bolts to the intake manifold.
Torque: 10 N·m {102 kgf·cm, 7 ft·lbf}
2. INSTALL NO. 1 INTAKE M
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0453 RL Speed Sensor Wrong Installation
History of rear speed sensor LH being installed incorrectly
Rear Speed Sensor LH PROCEDURE
1.
CHECK FOR DTCs (HEALTH CHECK) (a) Perform the Hea