Toyota Camry (XV70): Fail-safe Chart
Toyota Camry Repair Manual XV70 (2018-2024) / Power Source, Network / 2gr-fks (battery / Charging) / Charging System / Fail-safe Chart
FAIL-SAFE CHART
If the following DTC is stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
|
DTC No. | Fail-safe Operation |
Fail-safe Deactivation Condition |
|---|---|---|
|
P161A87 | Generator command is fixed. |
Engine switch is turned on (IG) after condition returns to normal. |
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts.
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Charging System
DTC No. Detection Item
Warning Indicate Memory
Note Link
P161A87 Lost Communication with Alternator Missing Message
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT
NOTICE: If the battery is weak or if the engine is difficult to start, recharge the battery and perform inspections again before returning the vehicle t
SEE MORE:
Green Indicator Remains Off
DESCRIPTION After engine switch on (IG), the DCM (telematics transceiver) will enter into self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn off followed by the manual (SOS) switch green indicator illuminating and remaining on under normal operation. If nei
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly (TWC: Rear Catalyst), center exhaust pipe assembly and tail exhaust pipe a
© 2023-2026 Copyright www.tocamry.com
