Toyota Camry owners & service manuals

Toyota Camry (XV70): On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

NOTICE:

If the battery is weak or if the engine is difficult to start, recharge the battery and perform inspections again before returning the vehicle to the customer.

PROCEDURE

1. CHECK BATTERY CONDITION

(a) Check the battery for damage or deformation. If severe damage, deformation or leakage is found, replace the battery.

(b) Check the electrolyte level in each cell.

(1) For maintenance-free batteries:

  • If the electrolyte level is below the lower line, replace the battery.
  • If the electrolyte level is above the lower line, check the battery voltage when cranking the engine. If the voltage is less than 11 V, recharge or replace the battery.

    HINT:

    Before checking the battery voltage, turn off all the electrical systems (headlights, blower motor, rear window defogger, etc.).

(2) For non-maintenance-free batteries:

  • If the electrolyte level is below the lower line, add distilled water to each cell. Then, recharge the battery and check the electrolyte specific gravity.

    Standard Specific Gravity:

    1.25 or higher at 20

    READ NEXT:

     Lost Communication with Alternator Missing Message (P161A87)

    DESCRIPTION The ECM communicates with the generator assembly via LIN communication. If a LIN communication error is detected, the ECM stores this DTC. DTC No. Detection Item DTC Detection

     Charging Failure

    PROCEDURE 1. CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION) (a) Start the engine and visually check that the generator rotor assembly (fan) in the generator assembly is opera

     Noise Occurs from V-ribbed Belt or Generator Assembly

    PROCEDURE 1. CONFIRM PROBLEM SYMPTOM (a) Confirm the problem symptom. Symptom Proceed to Noise occurs from V-ribbed belt. A Noise occurs from generator assembly

    SEE MORE:

     Check Bus 1 Lines for Short Circuit

    DESCRIPTION There may be a short circuit between the CAN main bus lines and/or CAN branch lines when the resistance between terminals 23 (CA1H) and 8 (CA1L) of the central gateway ECU (network gateway ECU) is below 54 Ω. Symptom Trouble Area Resistance between terminals 23 (CA1H

     If the electronic key does not operate properly (vehicles with a smart key system)

    If communication between the electronic key and vehicle is interrupted or the electronic key cannot be used because the battery is depleted, the smart key system and wireless remote control cannot be used. In such cases, the doors and trunk can be opened and the engine can be started by followin

    © 2023-2026 Copyright www.tocamry.com