Toyota Camry (XV70): Inspection
Toyota Camry Repair Manual XV70 (2018-2024) / Suspension / Rear Suspension / Rear Shock Absorber / Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SHOCK ABSORBER ASSEMBLY
(a) Compress and extend the rear shock absorber assembly rod 4 or more times.
Standard:
When compressed and extended at a constant speed, the stroke of the shock absorber rod is smooth with no abnormal resistance or sounds. When extended, the shock absorber rod returns to its original position at a constant speed with no abnormal sounds.
HINT:
If there are any abnormalities, replace the rear shock absorber assembly with a new one.
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR SUSPENSION SUPPORT AS
Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY
CAUTION:
Always use a cloth to prevent shards of metal flying about due to the release of pressurized gas.
Always wear safety g
SEE MORE:
2gr-fks Air Cleaner Filter Element
ComponentsCOMPONENTS ILLUSTRATION
*1 AIR CLEANER CAP SUB-ASSEMBLY
*2 AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY RemovalREMOVAL PROCEDURE
1. SEPARATE AIR CLEANER CAP SUB-ASSEMBLY
(a) Disengage the 2 wire harness clamps.
(b) Disengage the 2 air cleaner
Terminals Of Ecu
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the O2 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
HINT: Measure the values on the wire harness side with the connecto
© 2023-2026 Copyright www.tocamry.com
