Toyota Camry owners & service manuals

Toyota Camry (XV70): Installation

Toyota Camry Repair Manual XV70 (2018-2024) / Suspension / Rear Suspension / Rear Shock Absorber / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL REAR SUSPENSION SUPPORT ASSEMBLY

(a) Secure the rear suspension support assembly in a vise using aluminum plates.

NOTICE:

Do not overtighten the vise.

(b) Install the rear suspension support assembly to the rear shock absorber assembly.

(c) Apply a few drops of adhesive to the threads of a new rear support to rear shock absorber nut.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

NOTICE:

Only apply adhesive to the nut if it is not supplied as a precoated part.

(d) Using SST and a 6 mm hexagon socket wrench, hold the rear shock absorber rod and tighten the rear support to rear shock absorber nut.

SST: 09729-97202

Torque:

Specified tightening torque :

25 N

    READ NEXT:

     Disposal

    DISPOSAL PROCEDURE 1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY CAUTION: Always use a cloth to prevent shards of metal flying about due to the release of pressurized gas. Always wear safety g

     Rear Stabilizer Bar (for 2wd)

     Components

    COMPONENTS ILLUSTRATION *1 NO. 1 FLOOR UNDER COVER *2 NO. 2 FLOOR UNDER COVER N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 REA

    SEE MORE:

     Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range (C10001C,C10051C,C100A62,C1A9346,C1A9445,C1A9447,C1A9487-C1A961C)

    DESCRIPTION When an internal malfunction is detected in the forward recognition camera, these DTCs are stored. DTC No. Detection Item DTC Detection Condition Trouble Area C10001C Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range A forw

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during clearance warning ECU assembly removal/installation are shown below. Necessary Procedure After Parts

    © 2023-2026 Copyright www.tocamry.com