Toyota Camry (XV70): Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL REAR SPOILER RETAINER (w/ Rear Spoiler)
except TRD:
Click here .gif)
2. INSTALL REAR SPOILER (w/ Rear Spoiler)
Click here
3. INSTALL LUGGAGE COMPARTMENT DOOR CUSHION
| (a) Engage the 8 claws to install 2 new luggage compartment door cushions. |
|
.png)
4. INSTALL LICENSE PLATE LIGHT ASSEMBLY (for LH Side)
Click here
5. INSTALL LICENSE PLATE LIGHT ASSEMBLY (for RH Side)
HINT:
Use the same procedure as for the LH side.
6. INSTALL LUGGAGE ELECTRICAL KEY SWITCH
Click here
7. INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here
8. INSTALL NO. 3 LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH
Click here
9. INSTALL REAR LIGHT ASSEMBLY LH
Click here
10. INSTALL REAR LIGHT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
11. INSTALL LUGGAGE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY
| (a) Install the luggage compartment door lock cylinder assembly with the 2 nuts. Torque: 5.5 N |
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 COWL SIDE TRIM SUB-ASSEMBLY LH
*2 FRONT DOOR OPENING TRIM WEATHERSTRIP LH
*3 FRONT DOOR SCUFF PLATE LH
*4 HOOD LOCK CONTROL LEVER
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
3. DISCONNECT FRONT DOOR
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT HEADLIGHT ASSEMBLY LH (for Bulb Type Turn Signal Light)
*a Component without harness connected
(Headlight Assembly LH) (a) Apply battery voltage to the headlight assembly LH and check that the Lo/Hi beam shade operates.
OK:
Condition
Right Front Wheel Speed Sensor Circuit Short to Ground or Open (C050614)
DESCRIPTION Refer to DTC C050612 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C050614 Right Front Wheel Speed Sensor Circuit Short to Ground or Open
A short or open circuit is detected in the speed sensor signal circuit for 0.12 seconds or
