Toyota Camry owners & service manuals

Toyota Camry (XV70): Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE LH

Click here

2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Click here

3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Click here

4. REMOVE INSTRUMENT SIDE PANEL LH

Click here

5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

6. REMOVE NO. 2 METER HOOD CLUSTER

Click here

7. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

8. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY

Click here

9. REMOVE LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY

(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the luggage compartment door opening switch assembly as shown in the illustration.

*a

Protective Tape

Remove in this Direction

    READ NEXT:

     Inspection

    INSPECTION PROCEDURE 1. INSPECT LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY (a) Check the switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resi

     Installation

    INSTALLATION PROCEDURE 1. INSTALL LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY (a) Engage the 2 claws to install the luggage compartment door opening switch assembly as shown in the illustratio

     Luggage Compartment Door Opener Outer Switch

    ComponentsCOMPONENTS ILLUSTRATION *1 LUGGAGE COMPARTMENT DOOR COVER *2 LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY *3 LUGGAGE ELECTRICAL KEY SWITCH

    SEE MORE:

     Software Incompatibility with Cruise Control Module Invalid/Incompatible Software Component (U030557)

    DESCRIPTION The millimeter wave radar sensor assembly receives vehicle information from the forward recognition camera via CAN communication. If the vehicle information stored in the forward recognition camera differs from that stored in the millimeter wave radar sensor assembly, the millimeter wa

     Acn Call End

    ACN CALL END ACN CALL END This function terminates the ACN (Automatic Collision Notification) to the telematics provider. After a collision in which the DCM receives "Collision Detection Signal", the vehicle will send the emergency call notification to the telematics provider until the emergency cal

    © 2023-2026 Copyright www.tocamry.com