Toyota Camry (XV70): Installation
INSTALLATION
CAUTION / NOTICE / HINT
PROCEDURE
1. INSTALL CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (w/o Smart Key System)
(a) Engage the clamp.
(b) Connect the central gateway ECU (network gateway ECU) connector.
(c) Install the central gateway ECU (network gateway ECU) with the nut.
Torque:
7.5 N
READ NEXT:
COMPONENTS ILLUSTRATION
*1 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU
*2 NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
N*m (kgf*cm, ft.*lbf): Sp
SEE MORE:
REPLACEMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during automatic transaxle fluid replacement are shown below. Necessary Procedures After Parts Removed/In
SYSTEM DIAGRAM
Transmitting ECU (Transmitter)
Receiving ECU Signal
Communication Method
Skid control ECU (brake actuator assembly)
Steering angle sensor Steering angle sensor request signal
CAN communication line
Steering angle sensor