Toyota Camry (XV70): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY
(a) Engage the 2 claws.
(b) Engage the 2 clamps to install the No. 1 interior illumination light assembly.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
.gif)
3. INSTALL FRONT DOOR TRIM PLATE (w/o Courtesy Light)
Click here
4. INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
Click here
5. INSTALL FRONT ARMREST ASSEMBLY
Click here
6. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
8. INSTALL FRONT DOOR ARMREST COVER SUB-ASSEMBLY
Click here
9. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
Click here
10. INSPECT POWER WINDOW OPERATION
Click here
READ NEXT:
SEE MORE:
Active Control Engine Mount System
DESCRIPTION LOCATION
*1 Vacuum Switching Valve (for Active Control Engine Mount System)
*2 Front Engine Mounting Insulator
*3 Rear Engine Mounting Insulator
- -
The active control engine mount system decreases engine vibration at a low engine speed using th
ABS Malfunction (C1296)
DESCRIPTION If a malfunction in the speed sensor signal circuit or yaw rate and acceleration sensor (airbag sensor assembly) circuit occurs, the 4WD ECU assembly will output this DTC.
The airbag sensor assembly has a built-in yaw rate and acceleration sensor.
DTC No. Detection Item
DT
