Toyota Camry (XV70): Operation Check
OPERATION CHECK
TOYOTA ENTUNE APP SUITE CONNECT RESET PROCEDURE
(a) Duplicate the problem symptom.
(b) Check for DTCs and repair the systems for which any DTCs are output.
Click here .gif)
(c) Check cellular phone compatibility.
(1) Check if the cellular phone/vehicle is compatible (Refer to http://www.toyota.com/Entune/).
(2) If the cellular phone is not compatible, recommend to the customer a compatible cellular phone.
(d) Delete all paired devices from the cellular phone.
(1) The procedure varies based on phone model. Contact the service provider or cellular phone manufacturer if assistance is required.
(e) Remove the Toyota Entune App Suite Connect app from the phone.
NOTICE:
Only perform this step if the customer is present and approves.
(1) The procedure varies based on phone model. Contact the service provider or cellular phone manufacturer if assistance is required.
(f) Reset the phone.
NOTICE:
Only perform this step if the customer is present and approves.
(1) Turn off the phone and remove the battery for 15 seconds. For instructions on how to reset a cellular devices, refer to the appropriate manufacturer's website.
(g) Reinstall the Toyota Entune App Suite Connect app on the phone. (If removed.)
(1) The procedure varies based on phone model. Contact the service provider or cellular phone manufacturer if assistance is required.
(h) Delete all personal data from the radio and display receiver assembly.
(1) Delete all personal data from the radio and display receiver assembly.
NOTICE:
Only perform this step if the customer is present and approves.
HINT:
Re-installation of applications must be completed before applications will appear on the radio and display receiver assembly.
(i) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
(1) Record all radio station presets.
(2) Disconnect the cable from the negative (-) battery terminal and leave it disconnected for 2 minutes.
(j) Check if the problem symptom disappears.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
If the DCM (telematics transceiver) has been replaced, perform the DCM Activation procedure.
Click here
Before replacing the DCM (telematics transceiver), re
Terminals Of Ecu
TERMINALS OF ECU DCM (TELEMATICS TRANSCEIVER)
*a to Telephone Antenna (Sub)
*b to GPS Antenna
*c to Telephone Antenna (Main)
- -
Terminal No. (Symbol)
GPS Mark is not Displayed
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to
SEE MORE:
Air Vent cannot be Switched
DESCRIPTION If the air outlet mode does not change even though the air outlet display changes, the following suspected areas may be the cause.
Symptom Factor
Air outlet mode cannot be changed (air outlet display changes)
No. 1 air conditioning radiator damper servo sub-assembl
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK (a) Check fuel pump operation.
(1) Connect the Techstream to the DLC3. (2) Turn the engine switch on (IG).
NOTICE: Do not start the engine. (3) Turn the Techstream on.
(4) Enter the following menus: Powert
