Toyota Camry owners & service manuals

Toyota Camry (XV70): Pressure Control Solenoid "B" Actuator Stuck Off (P07757F)

DESCRIPTION

Based on signals from the transmission revolution sensors (NT and NC), the actual gear is detected.

The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical malfunctions of the solenoid valves, transmission valve body assembly and automatic transaxle assembly (clutch, brake, gear, etc.).

Actual gear when solenoid (SL2) valve malfunction occurs (without fail-safe control):

ECM commanded gear

1st

2nd

3rd

4th

5th

6th

7th

8th

*: Neutral

Actual gear during SL2 stuck ON malfunction

5th

5th

3rd to 5th

4th to 5th

5th

6th

7th

8th

Actual gear during SL2 stuck OFF malfunction

1st

2nd

3rd

4th

N*

N*

N*

N*

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Memory

Note

P07757F

Pressure Control Solenoid "B" Actuator Stuck Off

All of the following conditions are met (2-trip detection logic):

  • Engine coolant temperature is 40

    READ NEXT:

     Intermediate Shaft Speed Sensor "A" Circuit Short to Battery (P079112,P079114,P079131)

    DESCRIPTION The transmission revolution sensor (NC) detects the rotation speed of the counter gear which shows the output shaft speed of automatic transaxle assembly. Based on the transmission revol

     Pressure Control Solenoid "C" Circuit Short to Battery (P079512)

    DESCRIPTION Changing gears is performed by the ECM turning the solenoid (SL1, SL2, SL3, SL4, SL5 and SL6) valves on and off. If an open or short occurs in any of the solenoid valve circuits, the ECM

     Pressure Control Solenoid "C" Circuit Short to Ground or Open (P079514)

    DESCRIPTION Refer to DTC P079512. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P079514 Pressure Control Solenoid "C"

    SEE MORE:

     Registration

    REGISTRATION CAUTION / NOTICE / HINT NOTICE: When the automatic transaxle assembly is replaced, the transaxle compensation code must be registered to the ECM (proceed to Procedure 1). After the automatic transaxle assembly is installed, the Quick Response (QR) code label will be positioned w

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the susp

    © 2023-2025 Copyright www.tocamry.com