Toyota Camry (XV70): Problem Symptoms Table
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Sliding Roof / Convertible / Panoramic Moon Roof System / Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom | Suspected Area |
Link |
|---|---|---|
| Key-linked or wireless transmitter-linked function does not operate |
Refer to the "Key-linked or wireless transmitter-linked function does not operate". |
|
|
Key-off operation function operates even if operating conditions are not satisfied |
Refer to the "Key-off operation function operates even if operating conditions are not satisfied". |
|
|
Panoramic moon roof system does not operate |
Refer to the "Panoramic moon roof system does not operate". |
|
.gif)
READ NEXT:
Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)
(a) Disconnect the q1 sliding roof ECU (sliding roof drive gear assembly) connector.
(b) Measure the resistance and vo
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) Panoramic moon roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfuncti
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG). (c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Sliding Roof
SEE MORE:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
System Name See Procedure
Lane Tracing Assist System
Initialization
INITIALIZATION INITIALIZATION SERVO MOTOR (a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON. (c) Press the OFF switch. (d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization.
(f) According to the
© 2023-2026 Copyright www.tocamry.com
