Toyota Camry owners & service manuals

Toyota Camry (XV70): Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

HINT:

  • The following problem symptoms table is based on the assumption that each system related to the combination meter assembly is normal.
  • Refer to System Description for details about the communication between the combination meter assembly and each ECU.

    Click here

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Meter or Gauge

Symptom

Suspected Area

Link

Speedometer malfunction

Speedometer circuit

Tachometer malfunction

Tachometer circuit

Fuel receiver gauge display malfunction

Fuel receiver gauge display circuit

Engine coolant temperature receiver gauge malfunction

Engine coolant temperature receiver gauge circuit

Warning or Indicator

Symptom

Suspected Area

Link

Fuel level warning light malfunction (Fuel receiver gauge is normal)

Combination meter assembly

Malfunction other than above

Combination meter assembly

Multi-information Display

Symptom

Suspected Area

Link

Multi-information display is not displayed

Combination meter assembly

Engine Oil Level Low Add or Replace display malfunction

Engine oil level sensor circuit

Windshield Washer Fluid Low display malfunction

Washer fluid level warning switch circuit

Oil Pressure Low Stop in a Safe Place See Owner's Manual display malfunction*

Engine oil pressure switch circuit

Malfunction other than above

Combination meter assembly

  • *: for 2GR-FKS
Buzzer

Symptom

Suspected Area

Link

Engine oil pressure warning buzzer malfunction*

Engine oil pressure switch circuit

Malfunction other than above

Combination meter assembly

  • *: for 2GR-FKS
Others

Symptom

Suspected Area

Link

Entire combination meter does not operate

Power source circuit

Operating ODO/TRIP switch (trip switch) does not change odometer/TRIP meter display

ODO/TRIP switch circuit

Operating steering pad switch does not change multi-information display

Steering pad switch circuit

Operating light control rheostat does not change light brightness

Light control rheostat switch circuit

Meter illumination is always dark

Illumination circuit (Meter illumination is always dark)

Meter illumination does not dim at night

Illumination circuit (Meter illumination does not dim at night)

Meter illumination does not dim when the taillights are turned on

Combination meter assembly

Other systems that use the speed signal do not operate normally

Speed signal circuit

    READ NEXT:

     Terminals Of Ecu

    TERMINALS OF ECU COMBINATION METER ASSEMBLY (a) Measure the voltage and resistance and check for pulses according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Si

     Diagnosis System

    DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here

    SEE MORE:

     A/F (O2) Sensor Signal Biased/Stuck Lean Bank 1 Sensor 1 Circuit Current Above Threshold (P219519,P219524,P219618,P219623,P219719,P219724,P219818,P219823)

    DESCRIPTION HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the air fuel ratio sensor. The air fuel ratio sensor generates voltage* that corresponds to the actual air fuel ratio. This sensor voltage is used to provide the ECM with feedback so that it can control the air fuel

     Operation Check

    OPERATION CHECK INPUT SIGNAL CHECK (a) Connect the Techstream to the DLC3. (b) Check the cruise control main switch using the Data List function of the Techstream (cruise control main switch, -SET switch, +RES switch and CANCEL switch). Click here INSPECT CRUISE CONTROL MAIN SWITCH (a) Turn

    © 2023-2026 Copyright www.tocamry.com