Toyota Camry owners & service manuals

Toyota Camry (XV70): Removal

Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Ua80e (automatic Transmission / Transaxle) / Combination Switch / Removal

REMOVAL

PROCEDURE

1. PRECAUTION

Click here

2. REMOVE NO. 1 METER HOOD CLUSTER

Click here

3. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Click here

4. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH

Click here

5. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

Click here

6. REMOVE SHIFT LOCK RELEASE BUTTON COVER

Click here

7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Click here

8. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

Click here

9. REMOVE COMBINATION SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

Click here

    READ NEXT:

     Inspection

    INSPECTION PROCEDURE 1. INSPECT COMBINATION SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) (a) Inspect the NORMAL mode switch: (1) Measure the resistance according to the value(s) in the tabl

     Installation

    INSTALLATION PROCEDURE 1. INSTALL COMBINATION SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) Click here 2. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Click here 3. INSTALL SHIFT LEVE

     Differential Case

    SEE MORE:

     Software Incompatibility with Body Control Module "B" (U1331)

    DESCRIPTION This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors. Blind Spot Monitor Master DTC No. Detection Item DTC Detection Condition Trouble Area U1331 Software Incom

     Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Battery or Open (P032515,P033015)

    DESCRIPTION Refer to DTC P032511. Click here HINT: When DTC P032515 or P033015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the ignition timing is delayed to its maximum retardation. Fail-safe mode continues until the engine switch is turned off. DTC No. Detection Ite

    © 2023-2026 Copyright www.tocamry.com