Toyota Camry (XV70): Automatic Transaxle Unit
Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Ua80e (automatic Transmission / Transaxle) / Automatic Transaxle Unit
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 NO. 1 OIL COOLER OUTLET TUBE SUB-ASSEMBLY
*2 NO. 1 TRANSMISSION OIL FILLER TUBE
*3 OIL COOLER UNION SUB-ASSEMBLY
*4 OVERFLOW PLUG
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE TRANSMISSION CONTROL SHAFT LEVER
(a) Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.
Inspection
INSPECTION PROCEDURE 1. INSPECT TRANSMISSION OIL CLEANER MAGNET
(a) Use the removed transmission oil cleaner magnets to collect any steel chips. Examine the chips and particles in the transaxle
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle carrier sub-assembly removal/installation are shown below. Necessary Procedures After Parts
Under Hood
UNDER HOOD GENERAL NOTES
Maintenance requirements vary depending on country.
Check the maintenance schedule in the owner's manual.
Following the maintenance schedule is mandatory.
Determine the appropriate time to service the vehicle using either miles driven or time (months) elapse
© 2023-2026 Copyright www.tocamry.com
