Toyota Camry (XV70): Changing the windshield wiper rest position/Lifting the windshield
wipers
When the windshield wipers are not being used, they retract to below
the hood. To enable the windshield wipers to be lifted when parking in
cold conditions or when replacing a windshield wiper insert, change
the rest position of the windshield wipers to the service position using
the wiper lever.
■ Raising the wipers to the service position
Within approximately 45 seconds
of turning the engine
switch off, move the wiper lever
to the
*1 or
*2
position and hold it for approximately
2 seconds or more.
The wipers will move to the service
position.

*1: For U.S.A.
*2: For Canada
■ Lifting the windshield wipers
While holding the hook portion
of the wiper arm, lift the windshield
wiper from the windshield.

■Lowering the windshield wipers to the retracted position
With the windshield wipers placed on the windshield, turn the engine switch
to "ON" position (vehicles without a smart key system) or IGNITION ON mode
(vehicles with a smart key system) and then move the wiper lever to an operating
position. When the wiper switch is turned off, the windshield wipers will
stop at the retracted position.
NOTICE
■When lifting the windshield wipers
- Do not lift the windshield wipers when they are in the retracted
position
below the hood. Otherwise, they may contact the hood, possibly resulting
in damage to a windshield wiper and/or the hood.
- Do not operate the wiper lever when the windshield wipers are lifted.
Otherwise,
the windshield wipers may contact the hood, possibly resulting in
damage to the windshield wipers and/or hood.
READ NEXT:
Opening the fuel tank
cap
Perform the following steps to open the fuel tank cap:
Before refueling the vehicle
Close all the doors and windows, and turn the engine switch off.
Confirm the typ
The Toyota Safety Sense 2.5+ consists of the following drive
assist systems and contributes to a safe and comfortable driving
experience:
Driving assist system
◆ PCS (Pre-Collision System)
◆
SEE MORE:
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio and display
DESCRIPTION Refer to DTC P001013. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P001100
Camshaft Position "A" - Timing Over-Advanced or System Performance Bank 1
Intake valve timing is stuck at a certain value wh