Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | NO. 2 PARKING BRAKE WIRE ASSEMBLY |
*2 | REAR DISC BRAKE ANTI-SQUEAL SHIM KIT |
|
*3 | REAR DISC BRAKE PAD |
*4 | REAR DISC BRAKE CYLINDER ASSEMBLY |
|
*5 | REAR NO. 1 DISC BRAKE ANTI-SQUEAL SHIM |
*6 | REAR NO. 2 DISC BRAKE ANTI-SQUEAL SHIM |
|
*7 | REAR DISC BRAKE ANTI-SQUEAL SHIM |
*8 | REAR DISC BRAKE PAD WEAR INDICATOR PLATE |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
● | Non-reusable part |
.png) |
Brake shim grease (Part No. 08887-80409) |
- | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to
Installation
INSTALLATION CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attentio
SEE MORE:
Cylinder 1 Injector "B" Circuit Open (P21CF13,P21D013-P21D413)
DESCRIPTION The D-4S system has two injection systems. One is an in-cylinder direct injection system that directly injects pressurized fuel into the combustion chamber. The other is an intake port injection system. The ECM determines the percentage of direct injection and port injection necessary in
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY
(a) Remove the 2 screws.
(b) Disengage the 4 claws to remove the No. 3 air duct sub-assembly.
2. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
(a) Disengage the 4 claws to remove the No. 2 air duct sub-a
© 2023-2026 Copyright www.tocamry.com
