Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*A | for Fold Down Seat Type |
- | - |
|
*1 | REAR SEAT CUSHION ASSEMBLY |
*2 | REAR SEAT CUSHION LOCK HOOK |
|
*3 | REAR SIDE SEATBACK ASSEMBLY LH |
*4 | REAR CENTER SEAT OUTER BELT ASSEMBLY |
|
*5 | REAR SEAT INNER BELT ASSEMBLY RH |
*6 | WASHER |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
● | Non-reusable part |
ILLUSTRATION
|
*A | for High Mounted Stop Light |
*B | for Window Defogger |
|
*1 | INNER ROOF SIDE GARNISH LH |
*2 | RADIO SETTING CONDENSER |
|
*3 | REAR DOOR OPENING TRIM WEATHERSTRIP LH |
*4 | CLIP |
.png) |
N*m (kgf*cm, ft.*lbf): Specified torque |
● | Non-reusable part |
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT RADIO SETTING CONDENSER (for High Mounted Stop Light) (a) With the radio setting condenser installed, check that there is no looseness or other abnormaliti
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ra
Pillar Speaker
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT DOOR OPENING TRIM WEATHERSTRIP
*2 FRONT NO. 3 SPEAKER ASSEMBLY
*3 FRONT PILLAR GARNISH
*4 CLIP
● Non-re
SEE MORE:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT
NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTAL
Radio Receiver Power Source Circuit
DESCRIPTION This is the power source circuit to operate the radio and display receiver assembly. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (R
© 2023-2026 Copyright www.tocamry.com
