Toyota Camry (XV70): Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE PANORAMIC MOON ROOF SYSTEM
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make notes of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
HINT:
The following items can be customized.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Power Window.
(5) Select the setting by referring to the table below.
Power Window|
Tester Display | Description |
Default | Setting |
ECU |
|---|---|---|---|---|
| Door Key P/W Up |
Function to close the power windows and sliding roof using the mechanical key |
OFF | 0:OFF,1:ON |
Main body ECU (Multiplex network body ECU) |
|
Door Key P/W Down | Function to open the power windows and sliding roof using the mechanical key |
OFF | 0:OFF,1:ON |
Main body ECU (Multiplex network body ECU) |
|
P/W Down W/ Transmit |
Function to open the power windows and sliding roof using the electrical key transmitter sub-assembly |
OFF | 0:OFF,1:ON |
Main body ECU (Multiplex network body ECU) |
(6) Enter the following menus: Customize Setting / Slide Roof.
(7) Select the setting by referring to the table below.
Slide Roof|
Tester Display | Description |
Default | Setting |
ECU |
|---|---|---|---|---|
| Front SW Auto Operation |
This function is used to enable or disable auto operation function. |
ON | 0:OFF,1:ON |
Sliding roof ECU (Sliding roof drive gear assembly) |
(8) Enter the following menus: Customize Setting / Security.
(9) Select the setting by referring to the table below.
Security|
Tester Display | Description |
Default | Setting |
ECU |
|---|---|---|---|---|
| Slide Roof Open Warning |
This function is used to enable or disable the sliding roof open warning. |
ON | 0:OFF,1:ON |
Main body ECU (Multiplex network body ECU) |
READ NEXT:
Initialization
INITIALIZATION INITIALIZE PANORAMIC MOON ROOF SYSTEM (FOR SLIDING ROOF)
NOTICE:
When the sliding roof glass sub-assembly, sliding roof housing panel or slide roof rail sub-assembly is adjuste
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in or
Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)
(a) Disconnect the q1 sliding roof ECU (sliding roof drive gear assembly) connector.
(b) Measure the resistance and vo
SEE MORE:
Right Rear Wheel ABS Hold Solenoid Control Circuit Short to Battery (C12E712,...,C12F249)
DESCRIPTION The ABS solenoid relay and solenoid valves are built into the brake actuator assembly.
The rear solenoid valve RH controls the brake fluid pressure of the rear wheel cylinder RH of the vehicle.
When this DTC is stored, the fail-safe function operates and the ABS solenoid relay is tur
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be di
