Toyota Camry (XV70): Cylinder Head Gasket
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (engine Mechanical) / Cylinder Head Gasket
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*A Type A
*B Type B
*1 IGNITION COIL ASSEMBLY
*2 VACUUM PUMP ASSEMBLY
*3 V-RIBBED BELT
*4 GENERATOR ASSEMBLY
*5
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during c
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 CYLINDER HEAD GASKET
(a) Place a new No. 2 cylinder head gasket on the cylinder block sub-assembly as shown in the illustration.
*a Lot No.
SEE MORE:
Removal
REMOVAL PROCEDURE 1. PRECAUTION
NOTICE:
When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
A commun
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION
When troubleshooting OBD II (On-Board Diagnostics) vehicles, the Techstream (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's ECM (Engine Control Module) can be then read.
OBD II regulation
© 2023-2025 Copyright www.tocamry.com
