Toyota Camry (XV70): Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / EMPS / Data List.
(f) According to the display on the Techstream, read the Data List.
Chassis > EMPS > Data List|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Meter Vehicle Velocity |
Vehicle speed from speedometer |
Min.: 0.0 km/h (0.0 MPH) Max.: 300.0 km/h (186.4 MPH) |
| - |
|
Wheel Speed Right | Rear right wheel speed |
Min.: 0 km/h (0 MPH) Max.: 255 km/h (158 MPH) |
| - |
|
Wheel Speed Left | Rear left wheel speed |
Min.: 0 km/h (0 MPH) Max.: 255 km/h (158 MPH) |
| - |
|
Engine/Power Management ECU Pseudo Engine Revolution |
Engine speed | Min.: 0 rpm Max.: 12800 rpm | No significant fluctuation |
Engine running at a constant speed |
|
Motor Actual Current |
Amount of current to motor |
Min.: -327.68 A Max.: 327.67 A |
Value changes in proportion to steering effort - The value increases when turning right and decreases when turning left |
Engine running and steering wheel being turned |
|
Command Value Current |
Requested current to motor |
Min.: -327.68 A Max.: 327.67 A |
Value changes in proportion to steering effort - The value increases when turning right and decreases when turning left |
Engine running and steering wheel being turned |
|
Steering Angle Velocity |
Steering angle speed |
Min.: -32768 deg/s Max.: 32767 deg/s |
Value changes in proportion to steering speed - The value increases when turning left and decreases when turning right |
Engine running and steering wheel being turned |
|
Thermistor Temperature |
ECU substrate temperature |
Min.: -50.0 |
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Power Steering System
DTC No. Detection Item
DTC Detection Condition
Warning Indicate Return-to-normal Condition
Note Link
C1511
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. CHECK STEERING EFFORT (TORQUE) NOTICE: These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag sy
Torque Sensor1 (C1511-C1514,C1517,C1521-C1523,C1528,C1531-C1555)
DESCRIPTION While torque sensor system, motor system or ECU system malfunctions are detected, the fail-safe function suspends power assist. However, power assist continues with limited assistance amou
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
(a) Install a new gasket to the water inlet with thermostat sub-assembly.
(b) Install the water inlet with thermostat sub-assembly with the 2 bolts and 2 nuts.
Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. CONNECT WATER
Components
COMPONENTS ILLUSTRATION
*1 NO. 1 FLOOR UNDER COVER
*2 NO. 2 FLOOR UNDER COVER
N*m (kgf*cm, ft.*lbf): Specified torque
- - ILLUSTRATION
*A w/ Fuel Outlet Valve Assembly
*B w/o Fuel Outlet Valve Assembly
*1 FUEL TANK ASSEMBLY
