Toyota Camry (XV70): On-vehicle Inspection
Toyota Camry Repair Manual XV70 (2018-2024) / Steering / Power Assist Systems / Power Steering System / On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK STEERING EFFORT (TORQUE)
NOTICE:
These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag system before servicing.
Click here .gif)
(a) Stop the vehicle on a level, paved surface and align the wheels straight ahead.
(b) Remove the horn button assembly.
Click here
(c) Connect the cable to the negative (-) battery terminal.
(d) Using a torque wrench, check that the steering wheel set bolt is properly tightened.
Torque:
62 N
READ NEXT:
Torque Sensor1 (C1511-C1514,C1517,C1521-C1523,C1528,C1531-C1555)
DESCRIPTION While torque sensor system, motor system or ECU system malfunctions are detected, the fail-safe function suspends power assist. However, power assist continues with limited assistance amou
Torque Sensor Zero Point Adjustment Undone (C1515)
DESCRIPTION This DTC does not indicate a malfunction. The power steering ECU (rack and pinion power steering gear assembly) stores this DTC when it determines that torque sensor zero point calibration
Torque Sensor Zero Point Adjustment Incomplete (C1516)
DESCRIPTION This DTC does not indicate a malfunction. The power steering ECU (rack and pinion power steering gear assembly) stores this DTC when it determines that torque sensor zero point calibration
SEE MORE:
Vehicle Speed Signal Circuit between Navigation ECU and Combination Meter
DESCRIPTION The navigation ECU receives a vehicle speed signal from the combination meter assembly.
HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assemb
Stop Lamp Relay Actuator Stuck Off (C13807F)
DESCRIPTION Refer to DTC C13807E. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C13807F Stop Lamp Relay Actuator Stuck Off
When the voltage at the +BS terminal is between 10 V or more and the stop light control relay (stop light switch asse
© 2023-2026 Copyright www.tocamry.com
