Toyota Camry (XV70): Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Head Up Display / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Head Up Display > Data List|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Total Distance Traveled |
Total driving distance |
Min.: 0, Max.: 16777215 |
Current total driving distance |
- |
| Total Distance Traveled - Unit |
Total driving distance unit |
km or mile | Current total driving distance unit |
- |
| +B Voltage |
Battery voltage | Min.: 0 V, Max.: 25.5 V or Unset |
11 to 14 V | - |
|
Illumination Rate from Illuminance Sensor |
Light control sensor input value |
Min.: 0 lx, Max.: 65535 lx or Unset |
Value according to the brightness is output |
0 is displayed when there is no light |
|
Vehicle Speed Meter | Vehicle speed input value (Brake ECU) |
Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) or Unset |
Almost the same as actual vehicle speed |
- |
| Engine RPM |
Engine speed | Min.: 0 rpm, Max.: 12701 rpm or Unset |
Almost the same as actual tachometer |
- |
| Brightness Up Switch |
Brightness up switch | OFF or ON |
OFF: Switch released ON: Switch pushed |
This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. |
|
Brightness Down Switch |
Brightness down switch |
OFF or ON | OFF: Switch released ON: Switch pushed | This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. |
|
Projection Position Up Switch |
Projection position up switch |
OFF or ON | OFF: Switch released ON: Switch pushed | This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. |
|
Projection Position Down Switch |
Projection position down switch |
OFF or ON | OFF: Switch released ON: Switch pushed | This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. |
|
Display Change Switch | Headup display switch (CAN communication line) |
OFF or ON | OFF: Switch released ON: Switch pushed | - |
|
Display Angle | Display angle of headup display |
Min.: -12.7 deg, Max.: 12.7 deg or Unset |
Current display angle of headup display |
|
| Ambient Temperature (Celsius) |
Outside temperature (Celsius) |
Min.: -40.0°C, Max.: 87.1°C or Unset |
Almost the same as actual outside temperature |
- |
| Ambient Temperature (Fahrenheit) |
Outside temperature (Fahrenheit) |
Min.: -40°F, Max.: 215°F or Unset |
Almost the same as actual outside temperature |
- |
| Illumination Rate from Light Control Sensor |
Light control sensor input value |
Min.: 0 lx, Max.: 65535 lx or Unset |
Value according to the brightness is output |
Not applicable to this vehicle |
|
LDA System | Existence of lane tracing assist system |
Without or With | Without: w/o Lane Tracing Assist System With: w/ Lane Tracing Assist System |
- |
| PCS System |
Existence of pre-collision system |
Without or With | Without: w/o Pre-collision System With: w/ Pre-collision System |
- |
| ICS System |
Existence of parking support brake system |
Without or With | Without: w/o Parking Support Brake System With: w/ Parking Support Brake System |
- |
| Radar Cruise System |
Existence of dynamic radar cruise control system |
Without or With | Without: w/o Dynamic Radar Cruise Control System With: w/ Dynamic Radar Cruise Control System |
- |
| Intuitive P/A System |
Existence of intuitive parking assist system |
Without or With | Without: w/o Intuitive Parking Assist System With: w/ Intuitive Parking Assist System |
- |
| Road Sign Assist System |
Existence of road sign assist system |
Without or With | Without: w/o Road Sign Assist System With: w/ Road Sign Assist System |
- |
| HV System Indicator |
Hybrid system indicator value |
Min.: -101%, Max.: 511% or Unset |
Current hybrid system indicator value |
Not applicable to this vehicle |
|
Navigation System | Existence of navigation system |
Without or With | Without: w/o Navigation System With: w/ Navigation System |
- |
| Master Caution Display Function |
Setting of master warning light |
OFF or ON | OFF: Master warning light not displayed ON: Master warning light displayed |
Displays customize setting of Master Warning Light Function |
|
Speed Limit Display Function |
Setting of speed limit display |
OFF or ON | OFF: Speed limit display not displayed ON: Speed limit display displayed |
Displays customize setting of Speed Limit Display Function |
|
Memory Call Link Function |
Setting of headup display memory call link function |
OFF or ON | OFF: Memory call link function off ON: Memory call link function on |
Displays customize setting of Memory Call Link Function |
|
Seat Switch Link Function |
Setting of headup display power seat switch link function |
OFF or ON | OFF: Power seat switch link function off ON: Power seat switch link function on |
Displays customize setting of Power Seat Switch Link Function |
|
ECO Drive Indicator Zone Display Function |
Setting of ECO driving indicator zone |
OFF or ON | OFF: Eco driving indicator zone not displayed ON: Eco driving indicator zone displayed |
Displays customize setting of ECO Driving Indicator Zone Display Function |
|
LVN System | Existence of traffic movement notification system |
Without or With | Without: w/o Traffic Movement Notification System With: w/ Traffic Movement Notification System |
- |
| Driver Emergency Stop Assist System |
Existence of driver emergency stop assist |
Without or With | Without: w/o Driver Emergency Stop Assist With: w/ Driver Emergency Stop Assist |
- |
HINT:
Depending on the specifications of the vehicle, some items may not be displayed.
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
ACTIVE TEST
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Head Up Display / Active Test.
(e) Perform the Active Test according the display on the Techstream.
Body Electrical > Head Up Display > Active Test|
Tester Display | Measurement Item |
Control Range | Diagnostic Note |
|---|---|---|---|
|
Color Test Screen (Black) |
Headup display (Black color) |
OFF or ON | - |
|
Color Test Screen (White) |
Headup display (White color) |
OFF or ON | - |
|
Color Test Screen (Red) |
Headup display (Red color) |
OFF or ON | - |
|
Color Test Screen (Green) |
Headup display (Green color) |
OFF or ON | - |
|
Color Test Screen (Blue) |
Headup display (Blue color) |
OFF or ON | - |
|
Color Test Screen (Color Bars) |
Headup display (Color bars) |
OFF or ON | - |
|
Color Test Screen (Adjustment) |
Headup display (Adjustment screen) |
OFF or ON | - |
|
Display Brightness | Headup display (Display brightness) |
0 to 100% | - |
|
Display Position | Headup display (Display position) |
Up (+3), Up (+2), Up (+1), Center, Down (-1), Down (-2) or Down (-3) |
- |
HINT:
Depending on the specifications of the vehicle, some items may not be displayed.
READ NEXT:
SEE MORE:
Cannot Switch to Automatic ID Registration Mode
DESCRIPTION When "Change Wheel" is selected on the multi-information display and the "OK" switch (steering pad switch assembly) is pushed and held, the system enters ID registration mode and the tire pressure warning light blinks 3 times.
The main body ECU (multiplex network body ECU) receives sig
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. TEMPORARILY INSTALL REAR AXLE CARRIER SUB-ASSEMBLY
(a) Temporarily install the rear axle carrier sub-assembly to the rear shock abso
