Toyota Camry (XV70): Disassembly

Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Interior / Heating / Air Conditioning / Compressor (for 2gr-fks) / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE COOLER COMPRESSOR BRACKET

(a) Disengage the clamp.

(b) Remove the screw and cooler compressor bracket.

2. REMOVE MAGNET CLUTCH ASSEMBLY

(a) Secure the compressor assembly with magnetic clutch in a vise between aluminum plates.

(b) Using SST, hold the magnet clutch hub.

SST: 09985-00270

HINT:

There is no set number of magnet clutch washers that are used for adjusting clutch clearance.

(d) Using a snap ring expander, remove the snap ring and magnet clutch rotor.

NOTICE:

Do not damage the seal cover of the bearing when removing the snap ring.

(e) Disconnect the connector.

(f) Using a snap ring expander, remove the snap ring and magnet clutch stator.

SEE MORE:

Multi-axis Acceleration Sensor Module "A" Missing Calibration (C051D54)

DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication. HINT: If a communica

Installation

INSTALLATION PROCEDURE 1. INSTALL CAMSHAFT TIMING GEAR BOLT (a) Make sure that the No. 1 cylinder is at TDC/compression. HINT: Check that the cutout of the camshaft timing gear assembly is at the top and align the timing mark (cutout) of the crankshaft pulley with the timing mark on the timing c

Toyota Camry (XV70): Disassembly

READ NEXT:

SEE MORE:

Multi-axis Acceleration Sensor Module "A" Missing Calibration (C051D54)

Installation