Toyota Camry owners & service manuals

Toyota Camry (XV70): Dtc Check / Clear

Toyota Camry Repair Manual XV70 (2018-2024) / Power Source, Network / Networking / Lin Communication System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body or Smart Key* / Trouble Codes.

  • *: w/ Smart Key System
Body Electrical > Main Body > Trouble Codes Body Electrical > Smart Key > Trouble Codes

(e) Check the details of the DTCs.

Click here

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body or Smart Key* / Trouble Codes.

  • *: w/ Smart Key System
Body Electrical > Main Body > Clear DTCs Body Electrical > Smart Key > Clear DTCs

(e) Clear the DTCs.

    READ NEXT:

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts.

     Diagnostic Trouble Code Chart

    DIAGNOSTIC TROUBLE CODE CHART LIN Communication System DTC No. Detection Item Link B1206 P/W Master Switch Communication Stop B1273 Sliding Roof ECU Communica

     P/W Master Switch Communication Stop (B1206)

    DESCRIPTION This DTC is stored when LIN communication between the multiplex network master switch assembly and main body ECU (multiplex network body ECU) stops for 10 seconds or more. DTC No.

    SEE MORE:

     Safety Connect

    Safety Connect is a subscription-based telematics service that uses Global Positioning System (GPS) data and embedded cellular technology to provide safety and security features to subscribers. Safety Connect is supported by Toyota's designated response center, which operates 24 hours per day,

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during VVT sensor removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Re

    © 2023-2026 Copyright www.tocamry.com