Toyota Camry (XV70): FL Speed Sensor Wrong Installation (X0451)
DESCRIPTION
|
Code | Tester Display |
Measurement Item | Trouble Area |
|---|---|---|---|
|
X0451 | FL Speed Sensor Wrong Installation |
History of front speed sensor LH being installed incorrectly |
Front speed sensor LH |
PROCEDURE
| 1. |
CHECK FOR DTCs (HEALTH CHECK) |
(a) Perform the Health Check using the Techstream.
| Result |
Proceed to |
|---|---|
| DTCs are not output |
A |
| DTCs are output |
B |
| B |
.gif) | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
.gif)
| 2. |
CHECK PART NUMBER (FRONT SPEED SENSOR LH) |
(a) Check that the front speed sensor LH is installed.
OK:
Proper front speed sensor LH is installed.
NOTICE:
If it is necessary to remove components in order to check the front speed sensor LH, follow the relevant installation and removal procedures and precautions for those components.
| NG | | REPLACE FRONT SPEED SENSOR LH |
|
| 3. |
CLEAR VEHICLE CONTROL HISTORY (RoB) |
(a) Using the Techstream, clear the Vehicle Control History (RoB).
Chassis > Brake > Utility|
Tester Display |
|---|
| Vehicle Control History (RoB) |
|
| 4. |
CHECK VEHICLE CONTROL HISTORY (RoB) |
(a) Using the Techstream, check for Vehicle Control History (RoB).
Chassis > Brake > Utility|
Tester Display |
|---|
| Vehicle Control History (RoB) |
| Result |
Proceed to |
|---|---|
| X0451 is not output |
A |
| X0451 is output |
B |
| A |
| USE SIMULATION METHOD TO CHECK
|
.gif)
| B |
| REPLACE FRONT SPEED SENSOR LH |
READ NEXT:
FR Speed Sensor Wrong Installation (X0452)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0452 FR Speed Sensor Wrong Installation
History of front speed sensor RH being installed incorrectly
RL Speed Sensor Wrong Installation (X0453)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0453 RL Speed Sensor Wrong Installation
History of rear speed sensor LH being installed incorrectly
RR Speed Sensor Wrong Installation (X0454)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0454 RR Speed Sensor Wrong Installation
History of rear speed sensor RH being installed incorrectly
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY
(a) Secure the front axle assembly in a vise using aluminum plates. NOTICE:
Do not overtig
Internal Control Module A/D Processing Performance Internal Electronic Failure (P060B49)
MONITOR DESCRIPTION This DTC is stored when a communication error occurs in the ECM.
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P060B49
Internal Control Module A/D Processing Performance Internal Electronic Failure
ECM main
