Toyota Camry (XV70): Freeze Frame Data
Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Navigation / Multi Info Display / Navigation System / Freeze Frame Data
FREEZE FRAME DATA
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Body Electrical > Navigation System > Trouble Codes(e) Select a DTC to display its freeze frame data.
LIST OF FREEZE FRAME DATA
(a) Refer to Data List / Active Test.
Click here
.gif)
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Navigation System
DTC No. Detection Item
Link B1324
Lost Communication with Meter
B1325 Lost Communication with HUD
Lost Communication with Meter (B1324,B1325)
DESCRIPTION These DTCs are stored when communication between the radio and display receiver assembly and combination meter assembly or headup display (meter mirror sub-assembly)* is not possible.
SEE MORE:
General maintenance
Listed below are the general maintenance items that should be
performed at the intervals specified in the "Owner's Warranty
Information Booklet" or "Owner's Manual Supplement/Scheduled
Maintenance Guide". It is recommended that any problem
you notice should be brought to the attention of your To
Calibration
CALIBRATION
NOTICE:
Initial AWD functions such as acceleration are sometimes affected unless backup memory is cleared.
When the yaw rate and acceleration sensor (airbag sensor assembly) is replaced, Reset Memory must be performed.
RESET MEMORY (a) Turn the ignition switch off. (b) Co
© 2023-2026 Copyright www.tocamry.com
