Toyota Camry owners & service manuals

Toyota Camry (XV70): Freeze Frame Data

FREEZE FRAME DATA

FREEZE FRAME DATA

(a) Whenever a DTC is detected, the windshield wiper motor motor assembly stores the current vehicle state as Freeze Frame Data.

CHECK FREEZE FRAME DATA

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Wiper / Trouble Codes.

Body Electrical > Wiper > Trouble Codes Body Electrical > Wiper

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Wiper Switch HI (Line)

Front wiper switch HI position signal (direct line)

OFF or ON

OFF: Front wiper switch not in HI position

ON: Front wiper switch in HI position

-

Wiper Stop Position

Windshield wiper motor assembly position

Store Are/Lower Rev Pos, Wipe Area or Upper Rev Pos

Store Are/Lower Rev Pos: Lower reverse position or lower

Wipe Area: Between lower reverse position and upper reverse position

Upper Rev Pos: Upper reverse position

-

Wiper Position

Windshield wiper motor assembly position

Store Are, Exchange Position or Wipe Area

Store Are: Out of wiper operating range

Exchange Position: Within wiper maintenance position

Wipe Area: Within wiper operating range

-

Status of Motor Lock

Windshield wiper motor assembly status

Normal or Lock

Normal: Operating normally

Lock: Malfunctioning

-

Status of Temperature Protection

Windshield wiper motor assembly temperature protection

Normal, LO Operation, INT Operation or Stop

Normal: Windshield wiper motor assembly temperature is below 95

    READ NEXT:

     Fail-safe Chart

    FAIL-SAFE CHART PROTECTION FUNCTION (a) The windshield wiper motor assembly operates the following protection functions if it detects an abnormal condition, in order to protect the wiper and washer sy

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a

     Diagnostic Trouble Code Chart

    DIAGNOSTIC TROUBLE CODE CHART Wiper and Washer System DTC No. Detection Item DTC Output from Link B1245 Lost Communication with Wiper ECU LIN Main Body

    SEE MORE:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL STUD BOLT HINT: If a stud bolt is deformed or its threads are damaged, replace it. (a) Using an E8 "TORX" socket wrench, install the 2 stud bolts to the exhaust manifold assembly LH (TWC: Front Catalyst). Torque: 19.5 N·m {199 kgf·cm, 14 ft·lbf}

     ECM/PCM Engine Off Timer Performance Signal Invalid (P261029,P261093)

    DTC SUMMARY DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P261029 ECM/PCM Engine Off Timer Performance Signal Invalid ECM internal malfunction ECM Comes on DTC stored SAE Code: P2610 P261093 ECM/PCM En

    © 2023-2026 Copyright www.tocamry.com