Toyota Camry (XV70): Wiper And Washer System
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Wiper / Washer / Wiper And Washer System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Check For Intermittent Problems
- Operation Check
- Utility
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Lost Communication with Wiper ECU LIN (B1245)
- ECU Malfunction (B1370)
- Wiper Switch Signal Mismatch between LIN and Line (B1372)
- Lost Communication with Wiper System LIN BUS (B1373)
- Wiper Motor Power Source Circuit
- Wiper and Washer Switch Circuit
- Washer Motor Circuit
- Washer Fluid Level Warning Switch Circuit
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the
Parts Location
PARTS LOCATION ILLUSTRATION
*1 WINDSHIELD WIPER MOTOR ASSEMBLY
*2 LEVEL WARNING SWITCH ASSEMBLY
*3 WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
*4 ENGINE ROOM
System Diagram
SYSTEM DIAGRAM FRONT WIPER AND WASHER SYSTEM
WASHER FLUID LEVEL WARNING SYSTEM
SEE MORE:
Engine Coolant Temperature Sensor 1 Signal Stuck in Range (P01152A)
DESCRIPTION Refer to DTC P011511. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P01152A
Engine Coolant Temperature Sensor 1 Signal Stuck in Range
Either of the following conditions is met (2 trip detection logic)
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT
(a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot.
Lithium Soap Base Glycol Grease (b) Install the No. 2 steering rack boot to the groove on the rack housi
© 2023-2026 Copyright www.tocamry.com
