Toyota Camry (XV70): Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
|
System Name | See Procedure |
|---|---|
|
Lane Tracing Assist System |
|
|
Pre-collision System | |
|
Parking Assist Monitor System | |
|
Panoramic View Monitor System |
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression | Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK | Off (Lock) |
|
Ignition Switch ACC |
ACC | On (ACC) |
|
Ignition Switch ON |
ON | On (IG) |
|
Engine Start | START |
On (Start) |
PRECAUTION FOR WASHER NOZZLE ADJUSTMENT
(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:
(1) The washer nozzle tip is made of resin and may be damaged.
(2) Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.
Click here .gif)
(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 WINDSHIELD WIPER MOTOR ASSEMBLY
*2 LEVEL WARNING SWITCH ASSEMBLY
*3 WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
*4 ENGINE ROOM
System Diagram
SYSTEM DIAGRAM FRONT WIPER AND WASHER SYSTEM
WASHER FLUID LEVEL WARNING SYSTEM
System Description
SYSTEM DESCRIPTION FRONT WIPER AND WASHER CONTROL FUNCTION
Control/Function Description
Wiper speed regulation Maintains the default speed of the wipers even when the supply voltag
SEE MORE:
Crankshaft Position Sensor "A" Circuit Intermittent (P03351F,P03352A,P033531)
DESCRIPTION Refer to DTC P033511. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P03351F
Crankshaft Position Sensor "A" Circuit Intermittent
Under conditions (a), (b) and (c), no crankshaft position sensor signal
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below. Necessary Procedure After Parts Removed/
