Toyota Camry (XV70): Check For Intermittent Problems
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Wiper / Washer / Wiper And Washer System / Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS
NOTICE:
- If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before operation history has been read and saved, the operation history information could be lost.
- The Operation History function uses the current system time of the Techstream and the time counter inside the controlling ECU to calculate the times shown in the operation history. For this reason, before reading the operation history, first make sure that the Techstream system clock is accurately set to the current time.
Check Operation History
HINT:
The windshield wiper motor assembly records the wiper and washer system operation history, which can be read using the Techstream.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Wiper / Utility / Operation History.
Body Electrical > Wiper > Utility|
Tester Display |
|---|
|
Operation History |
(e) Following the instructions on the screen, read and save the operation history.
|
Tester Display |
|---|
|
Motor Lock Detection |
|
Temperature Protection Detection |
|
Overvoltage Detection |
|
Low Voltage Detection |
Symptom Simulation
Click here .gif)
READ NEXT:
Operation Check
OPERATION CHECK CHECK SERVICE POSITION CONTROL
(a) Turn the ignition switch off. (b) Within approximately 45 seconds of turning the ignition switch off, hold the windshield wiper switch assembly in
Utility
UTILITY OPERATION HISTORY HINT: History of Reason for Operation: The windshield wiper motor assembly stores Operation History which can be read using the Techstream, when a malfunction of the wiper an
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration.*
Click here
*: w/ Smart Key System
HINT:
Use the
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Inst
Initialization Switch Error (for Test Diagnosis) (C2198)
DESCRIPTION The switch circuit inside the combination meter assembly turns on and off according to the steering pad switch assembly operation.
During test mode, the tire pressure warning light blinks at 0.125 second intervals when "Set Pressure" is selected on the multi-information display, and il
© 2023-2026 Copyright www.tocamry.com
