Toyota Camry (XV70): Utility
UTILITY
OPERATION HISTORY
HINT:
History of Reason for Operation: The windshield wiper motor assembly stores Operation History which can be read using the Techstream, when a malfunction of the wiper and washer system occurs.
Click here .gif)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Wiper / Utility.
(e) Following the instructions on the screen, save the operation history.
Body Electrical > Wiper > Utility|
Tester Display |
|---|
|
Operation History |
WIPER SPECIFICATION SWITCH
HINT:
This item is displayed on the Techstream, but cannot be operated as the auto wiper system is not available for this vehicle.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Steering Angle Sensor / Utility.
(e) According to the display on the Techstream, select Wiper Specification Switch.
Chassis > Steering Angle Sensor > Utility|
Tester Display |
|---|
|
Wiper Specification Switch |
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration.*
Click here
*: w/ Smart Key System
HINT:
Use the
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER MOTOR ASSEMBLY
(a) Disconnect the A31 windshield wiper motor assembly connector.
(b) Measure the voltage and resistance on the wire harness side connecto
Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTC (a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON. (c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT KNOCK CONTROL SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
1 - 2 25°C (77°F)
120 to 280 kΩ If the result is not
Components
COMPONENTS ILLUSTRATION
*1 LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH PROTECTOR
*2 LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
*3 NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
*4 NO. 3 LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH
*5 LUGGAGE COMP
