Toyota Camry (XV70): ECU Malfunction (B1370)
DESCRIPTION
This DTC is stored when the windshield wiper motor assembly detects an internal malfunction.
|
DTC No. | Detection Item |
DTC Detection Condition |
Trouble Area | Memory |
DTC Output from |
|---|---|---|---|---|---|
|
B1370 | ECU Malfunction | Detection condition:
| Windshield wiper motor assembly |
○ | Wiper |
PROCEDURE
|
1. | CLEAR DTC |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Trouble Codes.
(e) Clear the DTCs.
Body Electrical > Wiper > Clear DTCs
|
.gif)
|
2. | CHECK FOR DTC |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Wait 10 seconds or more.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Wiper / Trouble Codes.
(f) Check for DTCs.
Body Electrical > Wiper > Trouble Codes|
Result | Proceed to |
|---|---|
|
DTC B1370 is not output |
A |
| DTC B1370 is output |
B |
| A | .gif) |
USE SIMULATION METHOD TO CHECK
|
.gif)
| B | |
REPLACE WINDSHIELD WIPER MOTOR ASSEMBLY |
READ NEXT:
Wiper Switch Signal Mismatch between LIN and Line (B1372)
DESCRIPTION Under normal operation, the windshield wiper motor assembly receives operation signals from the windshield wiper switch assembly via LIN communication.
The windshield wiper motor assemb
Lost Communication with Wiper System LIN BUS (B1373)
DESCRIPTION The main body ECU (multiplex network body ECU) and windshield wiper motor assembly communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if comm
Wiper Motor Power Source Circuit
DESCRIPTION This circuit is the power source circuit for the windshield wiper motor assembly. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses of circuits related to this
SEE MORE:
Evaporator Temperature Circuit or Evaporator Fin Thermistor (B1413)
DESCRIPTION The No. 1 cooler thermistor is installed to the evaporator in the air conditioner unit to detect the temperature of the cooled air that has passed through the evaporator, which is used to control the air conditioning system. It sends signals to the air conditioning amplifier assembly. Th
Wheel Speed Sensor Signal Compare Failure (C124E62)
DESCRIPTION The skid control ECU (brake actuator assembly) measures the speed of each wheel by receiving signals from each speed sensor.
These signals are used for recognizing that all four wheels are operating properly.
Therefore, signals from all wheels must be equal.
DTC No. Detection
