Toyota Camry owners & service manuals

Toyota Camry (XV70): Inspection

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (fuel) / Fuel Pressure Sensor (for High Pressure) / Inspection

INSPECTION

PROCEDURE

1. INSPECT FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH)

NOTICE:

  • Do not remove the fuel pressure sensor from the fuel delivery pipe with sensor assembly LH.
  • If the fuel pressure sensor is removed, replace the fuel pressure sensor (fuel delivery pipe with sensor assembly LH) with a new one.

(a) Check the fuel pressure sensor output voltage.

(1) Apply 5 V between terminals 1 (VC) and 2 (E2).

NOTICE:

  • Be careful when connecting the leads as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
  • Do not apply more than 6 V to terminals 1 (VC) or 2 (E2).

HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.

*a

Component without harness connected

(Fuel Pressure Sensor)

*b

Voltage Applied between Terminals

(2) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

3 (PR) - 2 (E2)

Pressure not applied to fuel pressure sensor

Approximately 0.4 to 0.6 V*

*: The output voltage changes depending on the voltage applied to the terminals.

If the result is not as specified, replace the fuel pressure sensor (fuel delivery pipe with sensor assembly LH).

*a

Component without harness connected

(Fuel Pressure Sensor)

    READ NEXT:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL FUEL PIPE PLUG SUB-ASSEMBLY (a) Install a new O-ring, No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring and No. 3 fuel injector back-up ring to the

     Fuel Pump

     Components

    COMPONENTS ILLUSTRATION *1 REAR CENTER SEAT OUTER BELT ASSEMBLY *2 REAR SEAT CUSHION ASSEMBLY *3 REAR SEAT CUSHION LOCK HOOK *4 REAR SEAT INNER BELT ASSEMBLY RH

    SEE MORE:

     Adjustment

    ADJUSTMENT PROCEDURE 1. INSPECT PARKING BRAKE PEDAL TRAVEL (a) Completely release the parking brake pedal assembly. (b) Fully depress the parking brake pedal assembly to engage the parking brake. (c) Depress the parking brake pedal assembly again to disengage the parking brake. (d) Slowly

     On-vehicle Inspection

    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below. Necessary Procedures After Parts

    © 2023-2026 Copyright www.tocamry.com