Toyota Camry owners & service manuals

Toyota Camry (XV70): Inspection

INSPECTION

PROCEDURE

1. INSPECT FUEL PUMP ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

20°C (68°F)

0.45 to 0.55 Ω

If the result is not as specified, replace the fuel pump assembly.

*a

Component without harness connected

(Fuel Pump Assembly)

    READ NEXT:

     Installation

    INSTALLATION PROCEDURE 1. TEMPORARILY INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY (a) Turn the crankshaft pulley until the flat of the camshaft faces the fuel pump lifter assembly. HINT: Th

     Fuel Pump Ecu

     Components

    COMPONENTS ILLUSTRATION *A for Fold Down Seat Type - - *1 REAR CENTER SEAT OUTER BELT ASSEMBLY *2 REAR SEAT CUSHION ASSEMBLY *3 REAR SEAT CUSHION LOCK H

    SEE MORE:

     On-vehicle Inspection

    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below. Necessary Procedures After Parts

     Communication Error from ECM to VSC Invalid Serial Data Received (P163181)

    DESCRIPTION The skid control ECU (brake actuator assembly) sends signals such as brake request signals to the ECM. When the ECM detects logic error signals sent from the skid control ECU (brake actuator assembly) for a certain period of time, DTC P163181 is stored. DTC No. Detection Item

    © 2023-2025 Copyright www.tocamry.com