Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / General / Maintenance / A25a-fks Battery / Installation
INSTALLATION
PROCEDURE
1. INSTALL BATTERY
(a) Install the battery to the vehicle.
(b) Install the No. 2 battery clamp with the bolt to the battery clamp sub-assembly.
Torque:
18.5 N
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 RADIATOR CAP SUB-ASSEMBLY
*2 RADIATOR DRAIN COCK PLUG
*3 NO. 1 ENGINE UNDER COVER
- -
Replacement
REPLACEMENT CAUTION / NOTICE / HINT
CAUTION: Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coo
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below. Necessary Procedures After Parts Remo
Torque Converter Clutch Circuit Short to Ground (P074011)
DESCRIPTION Solenoid (SL) valve is turned on and off by signals from the ECM to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch.
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Not
© 2023-2025 Copyright www.tocamry.com
