Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL ANTENNA CORD SUB-ASSEMBLY
(a) Connect the connector to install the antenna cord sub-assembly.
HINT:
Use the same procedure for the RH side and LH side.
2. INSTALL NO. 2 AMPLIFIER ANTENNA ASSEMBLY
(a) Engage the 2 guides and install the No. 2 amplifier antenna assembly with the bolt.
Torque:
7.0 N
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of mem
Parts Location
PARTS LOCATION ILLUSTRATION
*1 ROOF CONSOLE BOX SUB-ASSEMBLY
*2 TELEPHONE MICROPHONE ASSEMBLY
*3 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY
- TV FUSE (for 9
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION
When troubleshooting OBD II (On-Board Diagnostics) vehicles, the Techstream (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's ECM (Engine Control Module) can be then read.
OBD II regulation
© 2023-2026 Copyright www.tocamry.com
