Toyota Camry owners & service manuals

Toyota Camry (XV70): Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:

90 N

    READ NEXT:

     Rear Axle Hub (for 2wd Without Electric Parking Brake System)

     Components

    COMPONENTS ILLUSTRATION *1 PARKING BRAKE SHOE ADJUSTING HOLE PLUG *2 REAR AXLE HUB AND BEARING ASSEMBLY *3 REAR DISC *4 REAR DISC BRAKE CALIPER ASSEMBLY *

     On-vehicle Inspection

    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL Click h

    SEE MORE:

     Operation Check

    OPERATION CHECK CHECK FUNCTION (a) Check that the key reminder warning buzzer sounds. (1) With the driver door closed, insert the key into the ignition key cylinder and then make sure that the ignition switch is off or ACC. (2) Check that the buzzer sounds intermittently if the driver door is open

     Emergency Call Switch Illumination Circuit

    WIRING DIAGRAM w/ Sliding Roof w/o Sliding Roof CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System. Click

    © 2023-2026 Copyright www.tocamry.com