Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL MAIN VALVE ASSEMBLY
(a) Apply gasoline to 2 new O-rings. Then install the O-rings to the fuel main valve assembly (for Low Pressure).
(b) Apply gasoline to 2 new O-rings. Then install the O-rings to the fuel main valve assembly (for High Pressure).
(c) Install the 2 fuel main valve assemblies to the fuel filter.
|
*1 | Fuel Main Valve Assembly (for Low Pressure) |
*2 | Fuel Main Valve Assembly (for High Pressure) |
|
*a | Identification Mark (Part Number) |
- | - |
NOTICE:
- Make sure that the O-rings are not cut or pinched during installation.
- The fuel main valve assembly (for Low Pressure) and fuel main valve assembly (for High Pressure) have identification marks (part numbers). If the parts are installed in the incorrect positions, the engine may stall. Therefore, make sure to install the parts in the correct positions.
|
A | Fuel Main Valve Assembly (for Low Pressure) |
23070-31*** |
| B |
Fuel Main Valve Assembly (for High Pressure) |
23070-36*** |
(d) Install the 2 clips to the fuel filter.
2. INSTALL FUEL PUMP
Click here
.gif)
3. INSTALL FUEL SENDER GAUGE ASSEMBLY
Click here
4. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY)
- -
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fu
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side turn signal light assembly with cover removal/installation are shown below. Necessary Procedure
Inspection
INSPECTION PROCEDURE 1. INSPECT NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
(a) Turn the roller by hand to check that it turns smoothly. HINT:
If the roller does not turn smoothly, replace the No. 1 valve rocker arm sub-assembly.
2. INSPECT VALVE LASH ADJUSTER ASSEMBLY
NOTICE
