Toyota Camry (XV70): Fuel Main Valve
READ NEXT:
COMPONENTS ILLUSTRATION
*1 FUEL PUMP
*2 FUEL SUCTION PLATE SUB-ASSEMBLY
*3 FUEL SENDER GAUGE ASSEMBLY
*4 FUEL FILTER
*5 FUEL MAIN VALVE ASSEMBLY (for Lo
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fu
INSTALLATION PROCEDURE 1. INSTALL FUEL MAIN VALVE ASSEMBLY
(a) Apply gasoline to 2 new O-rings. Then install the O-rings to the fuel main valve assembly (for Low Pressure).
(b) Apply gasoline to 2
SEE MORE:
INSTALLATION PROCEDURE 1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)
(a) Apply a light coat of engine oil to the O-ring of the VVT sensor. NOTICE:
If reusing the VVT sensor, be sure to inspect the O-ring. (b) Clean the bolt and bolt hole.
(c) Apply adhesive to 2 or 3 threads at the en
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 6 (CA3H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 21 (CA3L) of the central gateway ECU (network gateway ECU) and termina