Toyota Camry owners & service manuals

Toyota Camry (XV70): Black Out Tape (for Rear Door)

Components

COMPONENTS

ILLUSTRATION

*1

REAR ARMREST ASSEMBLY

*2

REAR DOOR ARMREST COVER SUB-ASSEMBLY

*3

REAR DOOR INNER GLASS WEATHERSTRIP

*4

REAR DOOR NO. 2 SERVICE HOLE COVER

*5

REAR DOOR TRIM BOARD SUB-ASSEMBLY

*6

REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

*7

NO. 1 DOOR SCUFF PLATE CLAMP

-

-

ILLUSTRATION

*1

REAR DOOR GLASS RUN

*2

REAR DOOR GLASS SUB-ASSEMBLY

*3

REAR DOOR NO. 1 VENT SEAL

*4

REAR DOOR PANEL PROTECTOR

*5

REAR DOOR QUARTER WINDOW GLASS

*6

REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

*7

REAR DOOR SERVICE HOLE COVER

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

ILLUSTRATION

*1

REAR DOOR FRAME GARNISH

*2

REAR DOOR LOWER OUTSIDE STRIPE

*3

REAR DOOR OUTSIDE STRIPE

*4

REAR DOOR WEATHERSTRIP

Non-reusable part

-

-

    READ NEXT:

     Front Bumper

     Components

    COMPONENTS ILLUSTRATION *1 COOL AIR INTAKE DUCT SEAL *2 FRONT BUMPER ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during

    SEE MORE:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY (a) Install a new fuel suction tube set gasket to the fuel tank assembly. (b) Set the fuel suction tube with pump and gauge assembly to the fuel tank assembly. NOTICE: Be careful not to bend the arm of the fuel se

     Precaution

    PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected. System See Procedure Lane Tracing Assist System

    © 2023-2026 Copyright www.tocamry.com