Toyota Camry (XV70): Front Bumper
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Exterior Panels / Trim / Front Bumper
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 COOL AIR INTAKE DUCT SEAL
*2 FRONT BUMPER ASSEMBLY
N*m (kgf*cm, ft.*lbf): Specified torque
- - ILLUSTRATION
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT CENTER ULTRASONIC SENSOR (w/ Parking Support Brake System)
Click here 2. REMOVE FRONT CORNER ULTRASONIC SENSOR (w/ Parking Support Brake System)
Click her
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
(a) Remove the bolt.
Remove in this Direction (b) Disengage the claw and guide as shown in the illustration to remove the map light bracket.
(c) Remove the 2 bolts and sliding roof drive gear sub-a
Internal Control Module Monitoring Processor Performance Watchdog/Safety MCU Failure (P060A47)
MONITOR DESCRIPTION The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, this DTC is stored.
DTC No. Detection Item
DTC Detection Cond
© 2023-2026 Copyright www.tocamry.com
