Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL SENDER GAUGE ASSEMBLY
(a) Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.
NOTICE:
Be careful not to bend the arm of the fuel sender gauge assembly.
(b) Engage the 2 clamps to connect the wire harness to the fuel suction plate sub-assembly.
NOTICE:
Do not damage the wire harness.
(c) Connect the fuel sender gauge assembly connector.
2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Click here
.gif)
READ NEXT:
Precaution
PRECAUTION
CAUTION:
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work
Parts Location
PARTS LOCATION ILLUSTRATION
*1 FUEL SENDER GAUGE ASSEMBLY
*2 FUEL PUMP (for Low Pressure)
*3 FUEL PUMP CONTROL ECU
*4 FUEL TANK ASSEMBLY
*5 FUEL SUCTION
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the susp
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. PREPARE VEHICLE FOR HEADLIGHT AIM ADJUSTMENT
(a) Prepare the vehicle:
Ensure that there is no damage or deformation to th
© 2023-2026 Copyright www.tocamry.com
