Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Suspension / Front Suspension / Front Lower Suspension Arm / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
(a) Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.
| (b) Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration. Torque: Bolt (1), (2) : 200 N |
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 FRONT SHOCK ABSORBER WITH COIL SPRING
*2 FRONT SPEED SENSOR
*3 FRONT STABILIZER LINK ASSEMBLY
*4 FRONT FLEXIBLE HOSE
*5 STEER
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during f
SEE MORE:
Engine Coolant Temperature Sensor 1 Circuit Short to Ground (P011511)
DESCRIPTION A thermistor, whose resistance value varies according to the engine coolant temperature, is built into the engine coolant temperature sensor. The structure of the sensor and its connection to the ECM are the same as those of the intake air temperature sensor.
Refer to DTC P011011. Clic
Inspection
INSPECTION PROCEDURE 1. INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
1 - 2 20°C (68°F)
33 to 39 Ω
© 2023-2026 Copyright www.tocamry.com
